Built-in emergency light for illumination at home or on the road Vehicle jumper cables 250 psi aircompressor for inflating tires and sports equipment Operates 115-volt AC or 12-volt DC products anywhere Provides up to 300 watts of AC power
found in 852-1840's reviews: First Rate - Loosing the power cord on the aircompressor is worth the purchase price.
Invertor works well, but keep in mind 300Watts of battery power is a small bucket of power, don't try any inductive loads. instant AC power - If your power goes out you can live, for a while, with no lights. Does what it was made to do - I don't know what the people are thinking that give this item a one and two star rating because it isn't a gasoline-powered portable generator. No where in the description does it say it's a gas-powered generator, and these people are belittling a product that they bought because they made a mistake by not researching what the product was and because they don't seem to know the difference between a portable power-pack and a real generator. This is a battery powered portable power unit, first and foremost. They also put a power inverter on it so that you can power small 110-volt tools if necessary but don't expect it to provide the power of a gas-generator or your ac-mains, and there's a 12-volt cigarette outlet too for 12-volt tools. They put a small compressor on it and it works fine for emergencies, but it's not meant to inflate tires all the time like a Campbell-Hausfield 10-hp dual-stage compressor with 50-gallon tank, it's an emergency convenience, and that's the point that should be remembered. The battery takes and hold a charge well and the unit supplies all the power I need for small emergency situations when traveling or at home during a minor power outage.
No, it won't run your TV set, it isn't meant to, but when used within it's meant capabilities it performs it's duties fine, such as running a nebulizer for emphazema medication during power outages, or running a small radio. But if you're needing to power large appliances, of course it won't work, you have to rate the power-source to the power consumption of the appliance, including startup surge capacity. In other words, read the power-rating on the appliance and look at the power rating of Xantrex, if the appliance meets or exceeds the rated load capacity of the Xantrex, don't plug it in, it isn't going to magically supply more power than it's capable of. If you want to run your TV, air-conditioner, hot-water heater, well pump, washer/dryer, dishwasher, home theater system, or refridgerator, then buy a gasoline powered generator instead. That's why I bought my 15-Kilowatt gas generator. Doesn't hold a charge! - I followed the charging instructions for the Power Pack 300 C. The Power Pack ran a 40 watt table lamp for 4 hours as promissed!
However the next time I charged the system the same thing happened. never worked but they replaced it -
We charged it immediately and put it away for our first power failure that didn't happened until last night (almost a year after buying it). Great item - I use it in the yard to replace a long and tangled power cord to weedwack, to trim my bushes, and light an area at night for 15 -20 mins with a 300 watt light. I use it all the time! - I used the aircompressor function to re-inflate it. It takes a long time to inflate tires, compared to those 50 cent air/water machines at the gas stations, but it gets the job done and I can take it with me. I get power for 2-3 hours.
Tank Size: 60 gallon vertical Max PSI: 135 PSI PSI: 11.3 CFM @ 90 PSI; 10.3 CFM @ 135 PSI Volts: 230 Volts Motor: 3 HP with thermal overload and manual reset - single phase motor
found in SS3L3's description:Product Description
Maximum airpower! More delivered air (CFM) gives you the power to do the job right and in less time.
found in SS3L3's reviews: Perfect -
I have owned this aircompressor for about two years now and it was worth every penny. The compressor is excellent, So far I have run my compressor about 100 hours thus far. It has always supplied my with an ample amount of air when using air tools except if I run my impact for 10 minuets continuously then it drops to 70 psi. I would recommend this compressor to any one with out hesitation. I turned it on two years ago and it has been on ever sense it kicks on about every hour because there is a leak I have not fixed in my air system. Yes it puts of a lot of heat but if you do the math PV=nRt you will see that a lot of heat is given off compressing that much air. As well as the complaints as to the power of the motor if they were true that would mean that the motor was only 30% efficient thus it would be putting out 2320 watts of heat which it is not. It is drawing more than enough power for 4 HP even with efficiency factored in so it is putting out at least 3 HP. Also in response to the allegations that the tank was going to over pressurize If the switch failed and it continued to run there is a spring loaded safety valve on the power switch on the compressor so it is not possible to over pressurize it, mine hits about 133 before it kicks off. A cheap way to get more CFM... but its still cheap. - This aircompressor is identical to my Ingersoll Rand SS3L3 compressor that I purchased through Northern Tool in the early summer of 2005. This is the first aircompressor that I have ever owned, so it was a learning experience from the start.
It is recommended that you purchase the IR SS3L3 startup kit as the compressor is delivered to you without any oil in it. When I plugged in the compressor to test it out, I found that the motor continued to run even as the gauge on the tank passed 130 psi.
I ran the compressor off and on for several months without any major issues. a little bit of die grinding, I rotated the tires on my car using the impact wrench and air ratchet, I used it to blow dust off my work bench and check the air in my tires on a routine basis. I bought the compressor because I have several project cars, and I would like to begin the serious work of restoring them. Recently, I have been looking at plans for a sandblasting cabinet, and I am starting to doubt that this compressor will stand up to the task of sand blasting for extended periods. Things I have learned about the compressor since its purchase that have led me to this conclusion:
1. (I swap between my compressor and my dryer on the only 230V outlet in my house). At startup the motor may approach its 3 peak horsepower, but during normal operation it may only be outputting half that power, so in truth it is essentially a 1. This borderline false advertising is similar to peak and RMS power ratings in audio amplifiers, though it is fairly standard operating procedure to rate motors in this fashion. Though it is quieter than a direct drive unit like the 30 gallon compressors sold at most hardware stores, 3450 RPM is still quite fast. With the pulley ratios, the compressor crank spins at 1200 RPM. Heavier duty systems might have the AC motor running at 1200-1750 RPM with the compressor running at ~700 RPM or less, resulting in a much quieter setup. If I could do it over, I would consider a slower, beefier unit with a true power rating that runs at a slower, more quiet speed. There is apparently no available rebuild kit for the compressor itself, according to the local IR dealer, though they do sell gaskets and the oiling kit. It is a two cylinder, single stage compressor. The "valves" in the head are what I believe are called "reed valves", which are simply spring loaded "fingers" that cover holes in the cylinder head, and they move with the blowing/sucking of air as the pistons move in the cylinders (no mechanical actuation of the valves). The compressor can run fairly hot, especially when pressurizing the tank from zero pressure. I would like to add an intercooler in line to the tank as the compressed air is quite hot, and I think the compressor itself could use some more cooling. I bought some copper to fab up a larger heat sink for the compressor housing, though I haven't made it yet. The flywheel on the compressor is designed to move air over the unit, but I still think the design needs improvement. This makes me want to install a condensor between the compressor and tank). Copper tubing is used to route compressed air from the compressor to the tank, and I think some improvements could be made there, as well. One could remove the compressor to change the oil, but a better soultion would be to insert a ball valve in the oil drain plug for easy draining.
IR sells the SS5L5, which uses the same 60 gallon tank, but a 5 HP split phase 3450 RPM motor running a different two piston single stage compressor. For someone considering more power, this unit is still quite affordable, but it will still have some of the drawbacks of this system.
My biggest complaints are the use of the split phase motor, the relatively cheap design of the compressor (aluminum rods and lack of rod bearings), the flimsy pressure switch, and the cheap fittings used all over the machine. I will continue to use this unit for some time, but I am already considering either building my own low RPM, true 4-5 HP aircompressor from various parts suppliers, or just purchasing a new one from a company like Eaton Compressor. Like houses, I think good advice for someone looking to buy an aircompressor is "buy the most you can afford". I for one like the idea of a compressor running at a quiet 750 RPM at a mere 73 dBa, as opposed to my high revving 1200 RPM SS3L3. Meanwhile, my criticisms of this unit are based on what I'd like to see in a compressor, that is all. With authorized IR dealers all over the country, getting parts (like gaskets, pressure switches, and oiling kits) is pretty painless.
Comes with 10-foot power cord that plugs into 12-volt car cigarette lighter Comes with 1 sports needle and 2 nozzle adapters
Inflates average tires in 5-7 minutes
Built-in work/emergency light
275 PSI high pressure aircompressor
found in 2014's description: com Review
It's about time somebody came out with one of these--hats off to Wagan! It's small, light, inexpensive, and needs only a 12-volt power supply. We doubt you'll be able to find a more versatile compressor for the price. --Kris Jensen-Van Heste
Product Description
The Wagan 3-in-1 AirCompressor is perfect for vehicles, bike tires, balls, air mattress, and more. A 12-volt power supply is all that is needed to run the unit. It has a 10 foot power cord and a 14-inch hose with tire-fill nozzle. The special features include a high pressure compressor that generates 275 PSI, high air flow inflator for quick inflation, built-in light, and pressure gauge.
Product Description
Handy portable air pump runs from the car cigarette lighter. Be prepared for the unexpected with 12V tire air inflators. Air Pump Inflates: Bike Tires, Car Tires (SUV, Truck), Athletic Balls, Air Mattresses, Rafts, Inflatable Furniture, Air Tools. Air Pressure (max)of Tire Inflator: 275PSI Special Features of this 12 Volt Auto Air Inflator: High Pressure 275 PSI High Air Flow Inflator Built-in Work light/Emergency light Inflates average sized tires (16') in 5-10 minutes Pressure Gauge Reader Continuous Usage Time: Tire Inflator Has A Heavy Duty Motor. Accessories: 3 Nozzle adapters: collar, tire inflator nozzle, sports needle 12V Power Cord: 10 ft cord High Pressure Air Hose: 14' Air Hose with quick release valve connector Power Source of Tire Inflators: 12V cigarette lighter accessory receptacle Low Power Consumption.
Three year limited warranty Cast-iron cylinder and stainless steel valves for cooler operation
Patent pending oil-lube system with ball bearing design
Direct drive, no belts or adjustments are necessary
2.5 horse power, 4-gallon oil-lube compressor
Max 100 PSI 25' Recoil hose, 2 inflation nozzles, inflation needles, inflation adpater, and tire chuck are included. Conveniently placed gauges for easy monitoring of air pressure Sturdy retractable handle for simple storage 3 gallon tank for greater stored airpower.
found in EX8000's description:Product Description
mfr: Campbell Hausfeld Air Products Campbell Hausfeld takes performance to the max by launching Maxus, a new brand of heavy-duty powered equipment for contractors and serious do-it-yourselfers. Maxus brand products were created to provide contractors with professional-grade tools durable and powerful enough to withstand the rigors of the jobsite. Unlike other new brands, Maxusprovides added security with its connection to Campbell Hausfeld, one of the oldest and most trusted brands in the power equipment industry. Founded in 1836 and headquartered in Harrison, Ohio, Campbell Hausfeld is a leading manufacturer and marketer of power tools.
Premium Electric Compressor - Contractor Model - 1.
Comes complete with gun and hopper, compressor, electric motor, 50' of air hose, 25' power cord, 2-wheel dolly and instructions Two interchangeable air stem nozzles to double the range of patterns and spray pressure Cool running, 1 HP capacitor-start electric motor drives a rotary vane compressor that produces up to 30 psi when used with 3/32" air nozzle
Additional features: tool-free adjustable depth of drive, nail lock out mechanism, tool-free adjustable exhaust, ???? air fitting, removable non-marring nose tip Selectable trigger, restrictive or contact actuation mode Power to drive nails (up to 3-1/2" x .131") into engineered lumber Delivers twice the life over previous tools Uses standard 22 degree 2" to 3-1/2" x .113" to .131" plastic collated round head framing nails.
Provides storage for air hose Includes dual quick connects for two separate air lines Provides up to 5000 hours of pump life
found in EX8200's description: It also offers a convenient control panel, hose rack, 26-gallon ASME tank code and compressor oil. This compressor is ideal for automotive and job site tasks.
Product Description
mfr: Campbell Hausfeld Air Products Campbell Hausfeld takes performance to the max by launching Maxus, a new brand of heavy-duty powered equipment for contractors and serious do-it-yourselfers. Maxus brand products were created to provide contractors with professional-grade tools durable and powerful enough to withstand the rigors of the jobsite. Unlike other new brands, Maxusprovides added security with its connection to Campbell Hausfeld, one of the oldest and most trusted brands in the power equipment industry. Founded in 1836 and headquartered in Harrison, Ohio, Campbell Hausfeld is a leading manufacturer and marketer of power tools.
Premium Cast Iron Single Stage Oil Lubricated Compressor - Commercial Model - 2 HP Running, Oil Lubricated, 26 Gallon Tank (Five Year Limited Warranty).